No, sticking doors and windows do not always indicate a significant problem. In a newly built home, some sticking is considered a normal part of the initial settling process as the structure acclimates to its environment, particularly during the first 12 months.
In our experience here in Colorado, this is often caused by seasonal expansion and contraction. For example, a door might stick during a wet spring due to moisture but swing freely again by late summer. Minor issues that can be resolved by adjusting a strike plate or planing the door are typically within normal construction tolerances.
However, you should be concerned if the sticking becomes permanent, progressively worsens over several months, or is accompanied by other red flags, such as:
- Stair-step cracks in masonry or brick veneer that radiate from the corners of the door or window frame.
- Changing gaps around the frames, such as a gap that is widening at the top while narrowing at the bottom.
- Cracks exceeding 1/4 inch in width, which are generally considered structurally significant.
Because Centennial and the Denver area have expansive clay soils and harsh freeze-thaw cycles, homes in our region can experience more pronounced movement. If you notice these progressive signs, it is important to have a professional evaluation to determine if the movement is harmless or requires stabilization.
Let us help you get your project started. If you are concerned about your home’s foundation, please contact us for a site evaluation and a custom quote.
Please consult a licensed contractor for definitive advice; verify licensure with the Colorado Department of Regulatory Agencies (DORA). Estimates are preliminary and subject to change after site inspection and a full scope review.
Related FAQs
-
Why does the Price per Helical Pier Vary Based on Installation Depth and Soil Conditions?
Read More »: Why does the Price per Helical Pier Vary Based on Installation Depth and Soil Conditions?The price per helical pier varies because soil conditions and installation depth directly dictate the amount of material, labor, and equipment required for a stable foundation. In the Centennial and Denver metro areas, these two factors are the primary cost…
-
Should I Expect a Higher Labor Cost for the Installation of Helical Piers Compared to Push Piers?
Read More »: Should I Expect a Higher Labor Cost for the Installation of Helical Piers Compared to Push Piers?No, you should generally expect lower labor costs for the installation of helical piers compared to push piers. According to the provided guide, labor costs are a significant variable in foundation repair pricing, and they differ based on the following…
-
Can a Contractor Provide an Accurate Cost Estimate for Push Versus Helical Piers without a Soil Analysis?
Read More »: Can a Contractor Provide an Accurate Cost Estimate for Push Versus Helical Piers without a Soil Analysis?No, a contractor cannot provide a finalized or precise cost estimate without considering soil conditions, which typically require a technical analysis. According to the provided content, a geotechnical analysis or soil testing is considered essential for several reasons: Determining Load…
-
Why are Helical Piers Sometimes More Expensive to Install than Push Piers?
Read More »: Why are Helical Piers Sometimes More Expensive to Install than Push Piers?While helical piers are often more affordable for lighter loads, several factors can make them more expensive than push piers depending on the specific project requirements. Key reasons why helical piers may involve a higher investment include: Manufacturing Complexity: Helical…
-
What Factors besides Pier Type Influence the Total Cost of Foundation Stabilization?
Read More »: What Factors besides Pier Type Influence the Total Cost of Foundation Stabilization?Beyond the specific type of pier selected, several environmental, structural, and logistical factors significantly influence the total cost of foundation stabilization in Colorado: Soil Conditions and Geology: The presence of expansive clay soils, which swell and shrink with moisture levels,…
