No, sticking doors and windows do not always indicate a significant problem. In a newly built home, some sticking is considered a normal part of the initial settling process as the structure acclimates to its environment, particularly during the first 12 months.
In our experience here in Colorado, this is often caused by seasonal expansion and contraction. For example, a door might stick during a wet spring due to moisture but swing freely again by late summer. Minor issues that can be resolved by adjusting a strike plate or planing the door are typically within normal construction tolerances.
However, you should be concerned if the sticking becomes permanent, progressively worsens over several months, or is accompanied by other red flags, such as:
- Stair-step cracks in masonry or brick veneer that radiate from the corners of the door or window frame.
- Changing gaps around the frames, such as a gap that is widening at the top while narrowing at the bottom.
- Cracks exceeding 1/4 inch in width, which are generally considered structurally significant.
Because Centennial and the Denver area have expansive clay soils and harsh freeze-thaw cycles, homes in our region can experience more pronounced movement. If you notice these progressive signs, it is important to have a professional evaluation to determine if the movement is harmless or requires stabilization.
Let us help you get your project started. If you are concerned about your home’s foundation, please contact us for a site evaluation and a custom quote.
Please consult a licensed contractor for definitive advice; verify licensure with the Colorado Department of Regulatory Agencies (DORA). Estimates are preliminary and subject to change after site inspection and a full scope review.
Related FAQs
-
Does the Type of Soil at my Property Impact the Cost per Helical Pier?
Read More »: Does the Type of Soil at my Property Impact the Cost per Helical Pier?Yes, the type of soil at your property significantly impacts the cost per helical pier. Soil composition is one of the most unpredictable factors in foundation pricing because it determines the equipment, labor, and pier specifications required for a successful…
-
How Many Helical Piers are Typically Needed for Standard Residential Foundation Stabilization?
Read More »: How Many Helical Piers are Typically Needed for Standard Residential Foundation Stabilization?The specific number of helical piers required for residential foundation stabilization is not a fixed figure, as it depends on several project-specific variables. According to the source content, the quantity needed is determined by: Because every property has unique underground…
-
What Factors besides Per-pier Cost should I Consider when Comparing These Two Foundation Repair Methods for my Property?
Read More »: What Factors besides Per-pier Cost should I Consider when Comparing These Two Foundation Repair Methods for my Property?When comparing steel push piers and helical piers for your property in Centennial, you must look beyond the initial per-pier price. Several technical and environmental factors will influence the overall effectiveness and total cost of the project: Related FAQs
-
How do Soil Conditions in Centennial and the Greater Denver Area Influence the Total Project Cost for Push Piers Versus Helical Piers?
Read More »: How do Soil Conditions in Centennial and the Greater Denver Area Influence the Total Project Cost for Push Piers Versus Helical Piers?In Centennial and the Greater Denver area, soil conditions—specifically the presence of expansive, bentonite-rich clay—are the primary drivers of total project costs. These soils influence expenses in the following ways: Related FAQs
-
What is the Average Price Range for Installing a Single Helical Pier?
Read More »: What is the Average Price Range for Installing a Single Helical Pier?Based on the provided content from ACN Construction, there is no specific “average price range” or flat dollar amount listed for the total cost of installing a single helical pier. The documentation emphasizes that costs are calculated on a custom…
