It is quite common to notice cracks in drywall and masonry during the first few years of a new home. Most of these occurrences are simply the result of materials drying, expanding, and contracting as the house acclimates to its environment, and they rarely signal a structural problem.
There are three main reasons these cracks appear:
- Drying Shrinkage: This is the most frequent cause. As lumber and drywall compound lose moisture and cure, hairline separations naturally form at seams, corners, and door frames.
- Thermal Expansion and Contraction: Seasonal temperature changes cause framing, drywall, and masonry to expand in the summer and shrink in the winter, which pulls at the joints.
- Minor Foundation Settlement: As the soil beneath your new home compresses slightly under the weight of the structure, minor movement can occur. This typically results in cosmetic hairline fissures or nail pops.
While some movement is a normal part of new construction—especially in the expansive clay soils common in the Centennial area—certain patterns warrant a closer look. You should monitor for stair-step cracks in brick or block veneer that follow mortar joints in a zigzag pattern, or cracks that exceed 1/4 inch in width. If you notice these alongside sticking doors or uneven floors, the underlying movement may be structural rather than cosmetic.
We recommend documenting any new cracks with photos and monitoring them for at least two seasons. If you notice cracks widening or moving progressively, we can provide a thorough assessment to determine if deeper stabilization is needed. Let us help you get your project started by scheduling a consultation to evaluate your home’s specific conditions.
Please consult a licensed contractor for definitive advice; verify licensure with the Colorado Department of Regulatory Agencies (DORA). Project outcomes and timelines may vary based on site conditions.
Related FAQs
-
Do Sticking Doors and Windows in a New Home Always Indicate Significant Foundation Settlement?
Read More »: Do Sticking Doors and Windows in a New Home Always Indicate Significant Foundation Settlement?No, sticking doors and windows do not always indicate a significant problem. In a newly built home, some sticking is considered a normal part of the initial settling process as the structure acclimates to its environment, particularly during the first…
-
How do Engineers Calculate the Ultimate Geotechnical Capacity of a Helical Pile?
Read More »: How do Engineers Calculate the Ultimate Geotechnical Capacity of a Helical Pile?To calculate the ultimate geotechnical capacity of a helical pile, our engineers utilize three complementary approaches that combine soil mechanics theory with real-world field verification: We always apply a safety factor—typically between 2.0 and 3.0—to these ultimate capacity results to…
-
Does the Water Table Level Affect the Soil Bearing Capacity for Helical Piers?
Read More »: Does the Water Table Level Affect the Soil Bearing Capacity for Helical Piers?Yes, the water table level significantly influences soil bearing capacity for helical piers. Groundwater conditions can alter the engineering properties of the soil, which our team must account for during both the design and installation phases. Saturated soils experience reduced…
-
What is the Relationship between Installation Torque and Soil Bearing Capacity?
Read More »: What is the Relationship between Installation Torque and Soil Bearing Capacity?The relationship between installation torque and soil bearing capacity is governed by an empirical correlation that allows us to estimate the ultimate load-bearing strength of a pier based on the rotational force required to install it. This is expressed through…
-
How is the Soil Bearing Capacity Determined for Helical Pier Installation?
Read More »: How is the Soil Bearing Capacity Determined for Helical Pier Installation?To determine soil bearing capacity for helical pier installation, we use a multi-layered approach that combines theoretical engineering, real-time field measurements, and specialized testing. Our process ensures that structural loads are transferred past weak surface soils—such as the expansive clay…
